VAG ECU TOOL is for the complete access to all EEpromdaten with VAG-engine control units of type EDC15 and ME7

1. Read and write access to the EEprom
2. Reading the secret odometer (if stored in the engine control unit)
3. Immo-off function, login display, VIN change - everything about the diagnosis socket - not removing the ECU
4. With the write function is motor control "cloning" - no need to teach
5. Indispensable for workshops, recovery or Chiptuning

VAG ECU TOOL Functions of the program

1. serial EEprom read and save
2. EEprom checksum checking and correction
3. IMMO on / off
4. EEprom from a file and write (clone function)
5. Read / write access to the login
6. Read / write access to the chassis number
7. Read / write access to the Immobilizernummer
8. Kilometers Motronic in the read and write (if available)

In the ME7 .** controllers can also perform the following functions

1. Offset channels
2. Mixture enrichment
3. Idling torque change
4. Lambda value
5. Idle speed change
6. Correct charge (only for Turbo engines)
7. Ignition timing change

VAG ECU tool supports the following types of motor control of BOSCH

1. EDC15
2. EDC15VM
3. EDC15P
4. EDC15P + BOSCH ME7.5
5. BOSCH ME7.5.1
6. BOSCH ME7.1
7. BOSCH ME7.1.1